Navigate

Roadpost Support Center

or
Contact Us
  • Get in touch

    Send us an email

  • Start a chat session

  • Knowledgebase Read help articles
  • Contact Us We are here to help
  • Portal
  • Knowledgebase
  • 9505A Handset
  • 2015 Iridium Time Change (Re-Epoch) for Iridium 9505A, 9555 & Extreme
Subscribe Download PDF

2015 Iridium Time Change (Re-Epoch) for Iridium 9505A, 9555 & Extreme

Lu Parente
2015-03-04
in 9505A Handset

Follow the instructions below to update the time settings of your Iridium 9505A, 9555 & Iridium Extreme due to the Iridium network time change/re-epoch.  The Iridium GO! will handle the time change automatically.

 

Note: For Iridium Satellite Phone users, the planned epoch time change on March 3, 2015 will have no impact to service availability and the ability to successfully complete phone calls, SMS messages, or establish data services. However, the displayed time and date will revert to December 29, 2007, 7:26:29 UTC and will progress on this baseline until phone settings are adjusted to the new Iridium epoch time.

 

Please be advised, these instructions should completed after March 3, 2015 in order to display the correct date and time. 

 

Solution: Restore Time Settings for Iridium 9555 & Iridium Extreme

1. Dial *#99#2014051114235500#

2. Press the green key

3. Power handset off

4. Power handset on

5. Allow handset to register to the network

6. Handset will now display the correct time

Note: If the time displayed is incorrect, check your time zone settings by proceeding with the following

7. Press Menu 

8. Scroll to Setup and press Select

9. Scroll to Time & Date and press Select

10. Scroll to Select Time Zone and press Select

11. Choose the desired UTC time zone and press Select

12. Handset will now display the correct time

 

Solution: Restore Time Settings for Iridium 9505A

1. Press Menu

2. Scroll to Phone Setup and press OK

3. Scroll to Set Time and Date and press OK

4. Scroll to Set Home Time + Date and press OK

5. Enter the current time in 24hr format and press OK

6. Enter the current date (dd/mm/yy) and press OK

7. Press and hold the C button to exit the menu

 

 

Rate the quality of this page

This page was helpful :) :( This page was not helpful

Quick Jump
  • Roadpost Support Center
  • Knowledgebase
  • Contact Us
Top
Helpdesk software provided by Deskpro