Navigate

Roadpost Support Center

or
Contact Us
  • Get in touch

    Send us an email

  • Start a chat session

  • Knowledgebase Read help articles
  • Contact Us We are here to help
  • Portal
  • Knowledgebase
  • GeoPro
  • GeoPro Safety Wearable
  • How-To
  • Sending a Play Sound command to the GeoPro Safety Wearable
Subscribe Download PDF

Sending a Play Sound command to the GeoPro Safety Wearable

Lu Parente
2019-07-04
in How-To

Sending a Play Sound command to the GeoPro Safety Wearable will trigger the device to play a loud audible tone for 15 seconds and flash the LED blue. This can be helpful if the device has been misplaced or in the event you have defined your own protocol for sending this type alarm to specific or groups of devices. 


Note: To send a Play Sound command to groups of devices, navigate to the Options menu followed by Groups.


Follow the instructions below on how send a Play Sound command to the GeoPro Safety Wearable using the GeoPro Web App.


1.  Navigate to the Devices tab and select the desired GeoPro Safety Wearable device from the list.

2. The device page for the selected device will be displayed, select Play Sound from the list.

3. The Play Sound command will be sent to the GeoPro Safety Wearable and it will begin playing an audible tone for 15 seconds using the loud speaker.

Note: The device must be powered on and have coverage to receive the command.


Rate the quality of this page

This page was helpful :) :( This page was not helpful

Quick Jump
  • Roadpost Support Center
  • Knowledgebase
  • Contact Us
Top
Helpdesk software provided by Deskpro